Flyer End Frame Assembly
| Locate and identify End Frame Parts: (4) Legs: 1 1/2" X 1 3/4" X 41 1/4" (4) Blocks: 1 1/2" X 1 3/4" X 21 1/2" (8) screws: 1/4" X 3" (16) washers: 1/4" flat (1) gauge pin Note: If you bought the optional Hutch Shelf, your rear Legs will be 70" tall instead of 41 1/4". If you bought the Standing Desk, all 4 Legs are 70" tall. |
 |
| Install 8 screws with 2
washers each, into sides of 4 Legs as shown. Wax screws prior to
insertion. Use gauge pin (marked "End Frame Only") to set height of screws.
|
 |
| Arrange legs so that the 32,
3/16" holes in each Leg are facing up. Arrange Blocks so that 1" diameter
pocket is likewise facing up. Make sure bottoms of Legs are pointing same
way, if so marked.
Drop Legs with Screws onto Blocks as shown.
|
 |
| Stationary Slides should be
placed diagonally under Leg and Block.
Make sure both washers for each screw are located under the head of the screw, and not between the wood parts. Snug Screws down but do not tighten.
|
 |
| Rotate Block as shown.
Tighten Screws
Assemble left End Frame.
|
 |