     |
Work & Equipment Surfaces 4 Work and Equipment Surfaces are standard.
|
|
 |
 |
Pull out Worksurfaces Both Worksurfaces pull in and out. Either can be pulled completely out. While in use, Worksurface can be extended about 18". With this extension, and clearance under the Front Rail, leg room is nearly unlimited. |
 |
 |
Multi-Angle Tilt Both Large and Small Worksurfaces can be tilted about 45 degrees positive or negative. Worksurfaces can also be used flat. Changing angle takes only 10 seconds, and no tools are required.
|
 |
Adjustable Height Left: All work and equipment surfaces are attached to legs with screws. Legs are drilled every 1" to accept these screws.
|
|
 |
 |
Plenty of Room Left: Monitor Shelf easily supports 2 heavy CRTs Right: Area under Small Worksurface. Flyer 44 pictured |
 |
 |
Equipment Bars Equipment Bars adjust to fit your stuff. On a 44" desk the area under the Small Work-surface is 24" X 41", total. |
 |
 |
Monitor Shelf 16" deep Monitor Shelf has 2 position fore & aft adjustment |