File Drawer Assembly
Note: Large Drawer & File Drawer assembles the same way. Large Drawer uses (2) Tie Rods and has no Drawer Pull.
| Locate File Drawer parts:
(2) Slides: 1 1/4" X 1 3/8" X 24 7/16" Thread (4) 1/4 " Nuts onto ends of (4) Tie Rods about 1/2". Do not use any of the (4) Flanged Nuts for this step. |
 |
 |
| Thread ends of (4) Tie Rods
with Nuts into Threaded Bushings in Drawer Front as shown. Drawer Front
and Drawer Back are similar, except Drawer Back has 2 notches., and does
not have any Threaded Bushings. Tighten 1/4" Nuts to anchor Tie Rods into the Drawer Front. |
 |
 |
| Stand Drawer Front / Tie Rod
assembly up.
Drop Drawer Sides and Drawer Bottom into place. Make Sure Drawer Bottom fits into groves in Drawer Sides and Drawer Front. Drop Drawer Back onto Tie Rods and secure with (4) 1/4" Flanged Nuts
|
 |
 |
| Place Drawer on
its side. Loosen Tie Rods and apply pressure to inside of Drawer side to
straighten Drawer up. Repeat for other side. Tighten Nuts.
Install Drawer Pull with 1 1/2" Screws with 1 washer each.
|
 |
 |
| Large Drawer &
File Drawer: Install (2) Slides onto underside
of Desk Rails using 2" Screws with (1) Washer for each screw.
Small Drawer: Install (2) Slides into underside of Monitor Shelf using 1 1/2" Screws with (1) Washer for each Screw. Wax slide contact area. |
||