Work Surface Assembly
| Locate and identify Work
Surface Parts: (1) Stop Rod: 1/2" diameter with turned down ends (2) Tilt Pins: 1/2" diameter X 2 5/8" long (2) Screws: 1/4" X 3" (2) Washers: 3/4" diameter (2) Left & Right Board Sides: 3/4" X 1 7/8" X 20" long (2) Moving Slides: 1 1/8" X 2 3/8" X 25 1/2" (1) Work Board: 3/4" X 20" X Length
|
 |
| Place Work Board on Monitor
Shelf or Rails of Desk Position with good side up Note: Small Work Board shown in this photograph
|
 |
| Screw hole in end of Work
Board is 8 13/16" from Front edge of Work Board for both the Large and
Small Work boards.
|
 |
| it Board Side onto Work Board.
Board Sides are either right or left handed. Right hand shown in
photograph.
Newer desks have non-handed Board Sides (slots in both sides) |
 |
| Attach Moving Slide to Work
Board. Moving Slides are either right or left handed. Use 1/4" X 3" screw
with 1 washer under head. Wax screw prior to insertion. Right hand Moving
Slide shown.
See photograph on page that follows for front view of Work Surface.
|
 |